Home --> Documentations --> PJLIB-UTIL Reference
Pool increment size for console CLI. Default: 256 bytes
Initial pool size for console CLI. Default: 256 bytes
Maximum command arguments. Default: 8
Maximum number of argument values of choice type. Default: 16
Maximum number of command history. Default: 16
Maximum length of command buffer. Default: 512
Maximum number of hints. Default: 32
Maximum short name version (shortcuts) for a command. Default: 4
Pool increment size for CLI. Default: 512 bytes
Initial pool size for CLI. Default: 1024 bytes
Pool increment size for telnet CLI. Default: 512 bytes
Initial pool size for telnet CLI. Default: 1024 bytes
Specifies whether CRC32 algorithm should use the table based lookup table for faster calculation, at the expense of about 1KB table size on the executable. If zero, the CRC32 will use non-table based which is more than an order of magnitude slower.
Maximum number of IP addresses in DNS A response.
This constant specifies the maximum names to keep in the temporary name table when performing name compression scheme when duplicating DNS packet (the pj_dns_packet_dup() function).
Generally name compression is desired, since it saves some memory (see PJ_DNS_RESOLVER_RES_BUF_SIZE setting). However it comes at the expense of a little processing overhead to perform name scanning and also a little bit more stack usage (8 bytes per entry on 32bit platform).
The interval on which nameservers which known to be bad to be probed again to determine whether it is still bad.
Default: 60 (one minute)
- See also:
The interval on which nameservers which are known to be good to be probed again to determine whether they are still good. Note that this applies to both active nameserver (the one currently being used) and idle nameservers (good nameservers that are not currently selected). The probing to query the "goodness" of nameservers involves sending the same query to multiple servers, so it's probably not a good idea to send this probing too often.
Default: 600 (ten minutes)
- See also:
The life-time of invalid DNS response in the resolver response cache. An invalid DNS response is a response which RCODE is non-zero and response without any answer section. These responses can be put in the cache too to minimize message round-trip.
Default: 60 (one minute).
- See also:
Maximum numbers of DNS nameservers that can be configured in resolver.
Maximum life-time of DNS response in the resolver response cache, in seconds. If the value is zero, then DNS response caching will be disabled.
Default is 300 seconds (5 minutes).
- See also:
Maximum size of UDP packet. RFC 1035 states that maximum size of DNS packet carried over UDP is 512 bytes.
Default: 512 byes
Maximum number of transmissions before timeout is declared for the query.
Default retransmission delay, in miliseconds. The combination of retransmission delay and count determines the query timeout.
Default: 2000 (2 seconds, according to RFC 1035)
Size of memory pool allocated for each individual DNS response cache. This value here should be more or less the same as maximum UDP packet size (PJ_DNS_RESOLVER_MAX_UDP_SIZE), since the DNS replicator function (pj_dns_packet_dup()) is also capable of performing name compressions.
Size of temporary pool buffer for parsing DNS packets in resolver.
Maximum server address entries per one SRV record
Timeout value for HTTP request operation. The value is in ms. Default: 60000ms
Macro PJ_SCANNER_USE_BITWISE is defined and non-zero (by default yes) will enable the use of bitwise for character input specification (cis). This would save several kilobytes of .bss memory in the SIP parser.
Maximum number of attributes in the STUN packet (for the new STUN library).
Maximum number of attributes in the STUN packet (for the old STUN library).
PJLIB-UTIL Open Source, small footprint, and portable asynchronous/caching DNS resolver, text scanner, STUN client, and XML library
Copyright (C) 2006-2009 Teluu Inc.